About the Adjustable Front Upper Control Arms

🛠️ Adjustable Front Upper Suspension Arms – Fine-Tune Your XP1 and XP2 Build.

Complete your front suspension setup with these adjustable upper suspension arms, specially designed forthe MMC XP1 and XP2 printable chassis. These arms allow precise alignment control and increased adjustability of the car's response.

Whether you're chasing optimal camber, caster, or front-end response, this 3D printable design gives you the flexibility and performance that competitive drifters demand.

🔧 Key Features:

Fully adjustable geometry: fine-tune camber angle

Designed for 3D printing

Lightweight, durable design – tested for RC drift use

Directly compatible with the MMC XP1 and XP2 chassis

Easy installation with standard RC hardware

⚠️ Note: Designed specifically for the MMC XP1 and XP2 drift chassis. Requires standard ball ends, screws, and heat-inserts (not included).

Works best when paired with the matching lower suspension arms ([link](https://cults3d.com/en/3d-model/game/mmc-xp1-optional-parts-adjustable-lower-control-arms)).

You can use these parts in conjunctioin with: [link](https://cults3d.com/en/3d-model/game/mmc-printable-rc-drift-balljoints-10mm-15mm-20mm-25mm)

A must-have if you want full control over your front-end setup.